Corner Sentry™ protectors add a protective layer to your vulnerable industrial corners. This product is a flexible EVA shield that absorbs impacts and guards both the corner and the vehicle.
Vehicle impact is a constant problem for industrial corners in heavy traffic areas. Typically, protectors made of metal are bolted or welded in place to spread the blow out to minimize impact. Corner Sentry™ protectors absorb the impact, Reducing or eliminating damage to both the corner and to the vehicle. The product is made of a bright Yellow EVA material that adds visibility to the area. It is tapered to provide protection to the corner while keeping a low profile. These industrial corner guards can be installed with mechanical fasteners, or with the use of Sentry's cinch straps (not included) to square posts or concrete columns.
Product name: Corner Sentry 4”x4”x42” tall - Federal Yellow (CG42FN)
Measurement: covers 4”x4” corner x 2” thick at corner x 1” thick at edge x 42” tall
Material: Ethylene vinyl acetate (EVA)
Material color:Federal Yellow
Warranty: 30 day limited warranty on all products with regard to manufacturing
Where is this made: Made in USA
Sentry recommends mechanical installation of corner protectors, using fasteners through the included fastener grommets. The specific type of fastener will depend on the substrate to which the Corner Sentry protectors will be attached. Corner Sentry protectors can also be installed on square posts by use of a 2”/50mm wide strap using the included belt recesses.
Users have reported using construction adhesives to attach the product to corners; if this type of installation is preferred Sentry HIGHLY recommends discussing this with an adhesives expert regarding the use of adhesives on a polyethylene product and the particular substrate to which it will be attached.